Filter
Top Products
Removal and replacement procedures 31
7.
Remove the SCSI backplane.
To replace the component, reverse the removal procedure.
Hot-plug SAS or SATA backplane
To remove the component:
1. Power down the server (on page 25).
2. Remove the bezel (on page 25).
3. Remove the access panel ("Access panel" on page 26).
4. Remove all hot-plug hard drives ("Hot-plug SAS and SATA hard drives" on page 27, "Hot-plug SCSI
hard drive" on page 27).
5. Disconnect the power and data cables.
6. Remove the hot-plug hard drive cage ("Hot-plug SCSI, SAS, or SATA hard drive cage" on page 30).
7. Remove the SAS or SATA backplane.