Filter
Top Products
3 • Operator Functions
3-16 SV40221 Rev. A
Setting the Insert Feeder(s)
Insert Feeders F and G feed items that do not require folding by the
machine. Depending on configuration, your machine may have no
Insert Feeders, one Insert Feeder or two Insert Feeders.
Insert Feeder F is capable of feeding thicker Inserts than Insert
Feeder G. Therefore, booklets must only be fed from Feeder F.
The Mail Piece Icon Tree for the job being run will show if the feeder
needs to be loaded and the Insert orientation. If you need help
understanding the Insert icons, refer to page 1-12 of this guide.
1. Adjust the side guides to
the width of the Inserts
being fed using the Side
Guide Adjustment Knob,
then back-off 1/4 of a turn.
This will set the correct
clearance between the
guides and Inserts.
2. Refer to the labels located on each Insert Feeder. Match your
insert type (Slip, Reply Envelope, Pre-Folded or Booklet) with the
relevant icon and colour indicator on each label. Where a range
of settings is indicated on the label, the thicker the insert, the
higher the number or letter that should be selected.
i.e., The blue Booklet range runs from 6 to 9 and from C to D.
A thin Booklet might be set to 6 or 7 and C, whereas a thick
booklet might need settings 9 and D to run effectively.
3. Set the blue separator
gap lever to the number
required.
SV40221 Rev A book.indb 3-16 9/14/2004 5:51:14 PM