Filter
Top Products
2-10 Pitney Bowes DA500/DA550 Operator Guide
2 • Setting Up the DA500/DA550 Printer
Connecting
the DA500/
DA550 to Your
Computer
4. Connecting the Parallel Cable or Serial Cable
Use the parallel cable supplied to connect the DA500/
DA550 to your computer, or use an approved serial cable.
Each end of the parallel cable has a connector. One end is
labelled “Printer” and the other is labelled “Computer.”
1. To connect the Parallel Cable to the printer, align
the end of the cable connector labelled “Printer”
with the parallel port on the interface panel at the
rear of the printer. (See the figure below.) Push the
cable connector into the port.
Serial Port
Power Receptacle
Fuse
Power Switch
2. Secure the connector by snapping the two wire
clips over the corresponding tabs on the connec-
tor, as shown in the figure below.
Parallel Port