Filter
Top Products
User’s Manual of WGSD-1022/WGSD-8000
- 251 –
------ -------- ------------ ------------ ----------- ---------- ---------
e1 48 5.15 50 1.789 No
e2 43 5.15 10 1.789 No
e3 Copper
Temp – Internally measured transceiver temperature.
Voltage - Internally measured supply voltage.
Current – Measured TX bias current.
Output Power – Measured TX output power.
Input Power – Measured RX received power.
Tx Fault – Transmitter fault
LOS – Loss of signal
Data ready – Indicates transceiver has achieved power up and data is ready.
N/A - Not Available, N/S - Not Supported, W - Warning, E - Error
5.15 Port Channel Commands
5.15.1 interface port-channel
The interface port-channel global configuration command enters the interface configuration mode of a specific port-channel.
Syntax
interface port-channel port-channel-number
port-channel-number — A valid port-channel trunk index.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
Seven supported aggregated links are defined, and per port-channel, up to 4 member ports.
Turning off auto-negotiation of an aggregate link may, under some circumstances, make it non-operational. If the other side has
auto-negotiation turned on, it may re-synchronize all members of the aggregated link to half-duplex operation, and may, as per
the standards, set them all to inactive.