Filter
Top Products
User’s Manual of WGSD-1022/WGSD-8000
- 300 –
Console(config)# interface ethernet e5
Console(config-if)# spanning-tree cost 35000
5.21.9 spanning-tree port-priority
The spanning-tree port-priority interface configuration command configures port priority. To reset the default port priority, use
the no form of this command.
Syntax
spanning-tree port-priority priority
no spanning-tree port-priority
priority — The port priority. (Range: 0 - 240 in multiples of 16)
Default Configuration
The default port-priority for IEEE STP is 128.
Command Modes
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the spanning priority on e5 to 96.
Console(config)# interface ethernet e5
Console(config-if)# spanning-tree port-priority 96
5.21.10 spanning-tree portfast
The spanning-tree portfast interface configuration command enables PortFast mode. In PortFast mode, the interface is
immediately put into the forwarding state upon linkup, without waiting for the timer to expire. To disable PortFast mode, use the
no form of this command.
Syntax
spanning-tree portfast
no spanning-tree portfast