Filter
Top Products
Store Commands
229
store pserver smb workgrp <WORKGROUP>
Example:
store pserver smb workgrp eng
Define a different Windows workgroup as defined by
<workgroup> for the NIC to be visible within (should be 14
characters or less). By default, the print server only comes up
within the group called “WORKGROUP.”
store pserver lpd [-]dest1default
Example:
store pserver lpd dest1default
If dest1default is disabled and upon verification, the printer
name supplied by the LPR protocol and the destination name
do not match, then an error message is returned and the
service is refused. If dest1default is enabled and upon
verification, the printer name supplied by the LPR protocol and
the destination name do not match, then the job is
automatically routed to the first destination and the service is
accepted.
Default: enabled
store pserver from default
Set all general print server settings back to factory defaults.
store pserver from current
Store all current general print server settings to flash memory
so they are retained after a power cycle. This ensures all
current settings match what is stored in flash memory.
store ptrmgmt pne <PNE PORT NUMBER>
Change the port number to communicate with Printnet
Enterprise.
Default: 9001
store ptrmgmt status <STATUS PORT NUMBER>
Example:
store ptrmgmt status 1025
Receives printer status, print job status, and/or emulation
verification data. The data sent through this port is defined by
the printer code.
Default: 9002