Q-Logic 3000 Switch User Manual


 
1–Switch Management Classes
QLGC_FCPortSettings : CIM_FCPortSettings
1-14 59223-03 E
If AutoSenseSpeed is set to TRUE, then changes to this property will
be ignored. As a result, the AutoSenseSpeed property should be
disabled BEFORE the RequestedSpeed property is changed, or they
should both be changed at the same time.
AutoSenseSpeed
Property will contain a boolean value indicating if the port is configured
to AutoSense the speed. This property overrides the RequestedSpeed
property. The active port speed is reported in the FCPort.Speed
property. This property may be edited if the value of the
EditAutoSenseSpeed property of the corresponding
FCPortCapabilities instance is TRUE.
RequestedType
Property will contain the configured port type. The active port type is
reported in the FCPort.PortType property. Valid values for this property
are reported by the RequestedTypesSupported property of the
corresponding FCPortCapabilities instance.
Possible values are:
2-G: Port may act as an E or F port.
3-GL: Port may act as an E, F, or FL port.
5-F: Port may only act as an F port.
6-FX: Port may act as an F or FL port.
16000-Donor: Port may not connect, it donates its credits for
use by another port.
QLogic Extended Properties and Methods
RequestedIOStreamGuardState
Property will contain the configured IOStreamGuard state. The
operational IOStreamGuard state is reported by the
FCPort.IOStreamGuard property. Valid values for this property are
reported by the SupportedIOStreamGuardStates property of the
corresponding FCPortCapabilities instance. IOStreamGuard should
only be enabled for ports that are connected to initiators.
Possible values are:
1 – AutoSense: Port will enable IOStreamGuard if connected to
an Initiator.
2 – Enable: Suppresses the reception of RSCN messages from
other ports for which I/O Stream Guard is enabled.
3 – Disable: Allows free transmission and reception of RSCN
messages.