Q-Logic 3000 Switch User Manual


 
2–Fabric Discovery Classes
QLGC_FCPort : CIM_FCPort
59223-03 E 2-7
(Remote)
0 Unknown
(NS) NULL
SupportedCOS
Property will contain an array of 0..N supported classes of service for a
port on an attached device (NS port). It will be NULL for switch ports.
SupportedFC4Types
Property will contain an array of 0..N supported FC4 Types for a port
on an attached device (NS port). It will be NULL for switch ports.
EnabledState
(Local)
Property will contain the current port enabled state. This value will
match the configured switch enabled state (EnabledDefault) unless the
switch state has been temporarily changed.
Supported values
02-Enabled - Port is enabled
03-Disabled - Port is disabled
07-InTest Port is in diagnostic mode
(NS/Remote) Property will contain the enumerated value 5=Not
Applicable.
RequestedState
(Local)
Property will contain the value 5=No Change. All port state changes
are atomic, so there will never be a pending requested state.
(NS/Remote)
Property will contain the enumerated value 12=Not Applicable
EnableDefault
(Local)
Property will contain the configured port state.
02-EnabledPort is enabled
03-DisabledPort is disabled
(NS/Remote)
Property will contain the enumerated value 5=Not Applicable.
RequestStateChange
(Local only)
Method will change the configured port state to the RequestedState
value. If the RequestedState parameter is 11-Reset, the port will be
reset, but the configured state will not change.