2–Fabric Discovery Classes
QLGC_FCPort : CIM_FCPort
2-8 59223-03 E
Parameters:
RequestedState: [required] A port specific array of valid values
may be found in the
FCPortCapabilities.RequestedStatesSupported property.
Parameter must be one of the following enumerated values.
2-Enabled: Port is online.
3-Disabled: Port is offline
7-Test: Port is in diagnostics mode.
11-Reset: Port will be reset.
Job: Ignored, command is synchronous.
TimeoutPeriod, must be zero second interval, or NULL,
command is synchronous.
Method Returns:
0 - Success
1 - Not Supported: (NS/Remote Ports) Method applies to local
ports only.
6 - In Use: Switch is being configured by another user;
4097 - Invalid State Transition: RequestedState parameter
value is out of range.
4098 – Use of Timeout Parameter Not Supported
Request Status Codes:
CIM_ERR_ACCESS_DENIED: User does not have
authorization for this command.
CIM_ERR_INVALID_PARAMETER: One or more required
parameters are missing.
CIM_ERR_NOT_FOUND: The FCPort instance was not found.
QLogic Extended Properties and Methods
HealthState
(Local Only)
This property will report the diagnostic status of the port as a result of
the Switch POST. Supported values are:
0 – Unknown Port is not installed
5 – OK No errors
25 – Critical Failure Port failed POST