B – Command Line Interface
Set Setup Command
59042-01 A B-37
Set Setup Command
Changes SNMP and system configuration settings. The switch maintains one
SNMP configuration and one system configuration.
Authority Admin
Syntax set setup
snmp
system
Keywords snmp
Prompts you in a line-by-line fashion to change SNMP configuration settings.
Table B- 11 describes the SNMP fields. For each parameter, enter a new value or
press the Enter key to accept the current value shown in brackets.
Table B-11. SNMP Configuration Settings
Entry Description
Contact Specifies the name of the person to be contacted to respond to
trap events. The default is undefined.
Location Specifies the name of the switch location. The default is
undefined.
Trap [1-5] Address Specifies the IP address to which SNMP traps are sent. The
default address for trap 1 is 10.0.0.254. The default address for
traps 2–5 is 0.0.0.0.
Trap [1-5] Port Specifies the port for which SNMP traps are sent.
Trap [1-5] Severity Specifies the severity level to use when monitoring trap events.
The default is Warning
Trap [1-5] Enabled Specifies whether traps (event information) are enabled or
disabled (default).
ReadCommunity Read Community Authentication. A write-only field; the value
on the switch and the SNMP management server must be the
same.
WriteCommunity Write Community Authentication. A write-only field; the value
on the switch and the SNMP management server must be the
same.
TrapCommunity Trap Community Authentication. A write-only field; the value on
the switch and the SNMP management server must be the
same.
AuthFailureTrap Specifies the IP address where a notification is sent in the
event of an authentication failure.