Q-Logic 8C Switch User Manual


 
B Command Line Interface
Test Command
59042-01 A B-61
Test Command
Tests I/O blades and ports using internal (SerDes level), external (SFP), and
online loopback tests. Internal and external tests require that the I/O blade or the
port be placed in diagnostic mode. Refer to the Set Command on page B-23 for
information about changing the port or I/O blade administrative state. While the
test is running, the remaining ports on the switch remain fully operational.
Authority Admin
Syntax test
port [port_number] [test_type]
blade [slot_number]
cancel
status
Keywords port [port_number] [test_type]
Tests the port given by [port_number] using the test given by [test_type]. If you
omit [test_type], Internal is used. [test_type] can have the following values:
internal
Tests the SerDes. This is the default. The port must be in diagnostics mode
to perform this test.
external
Tests both the SerDes and SFP. The port must be in diagnostics mode to
perform this test, and a loopback plug must be installed in the SFP.
online
Tests one online port.
cancel
Cancels the online test in progress.
status
Displays the status of a test in progress, or if there is no test in progress, the
status of the test that was executed last.
Examples To run an internal (SerDes) or external (SFP) port tests, do the following:
1. To start an admin session, enter the following command and press the Enter
key.
admin start
2. Place the port in Diagnostics mode, enter the following command (x = port
number) and press the Enter key.
set port x state diagnostics
3. Insert the loopback plug into the SFP on the selected port.