Q-Logic 8C Switch User Manual


 
B Command Line Interface
Set Config Command
59042-01 A B-25
Set Config Command
Sets switch, port, alarm threshold, and zoning configuration parameters.
Authority Admin authority and a Config Edit session
Syntax set config
port [port_number]
ports [port_number]
switch
threshold
zoning
Keywords port [port_number]
Initiates an edit session in which to change configuration parameters for the port
number given by [port_number]. If you omit [port_number], the system begins with
port 0 and proceeds in order through port 63. For each parameter, enter a new
value or press the Enter key to accept the current value shown in brackets. Enter
q to cancel the configuration for one port, or qq to cancel the configuration for
all ports. Table B-7describes the port parameters.
ports [port_number]
Initiates an editing session in which to change configuration parameters for all
ports based on the configuration for the port given by [port_number]. If you omit
[port_number], port 0 is used. For each parameter, enter a new value or press the
Enter key to accept the current value shown in brackets. Enter q to cancel the
configuration. Tabl e B-7 describes the port parameters.
Table B-7. Set Config Port Parameters
Parameter Description
AdminState Port administrative state: online, offline,
diagnostics, or down.
LinkSpeed 1Gb/sec or 2 Gb/sec
PortType Type of port
TLPortMode Initiates the configuration of ports
attributes. Indicates whether using initiator
or target devices on the loop. If you specify
[port_number], the display will present
attributes for that port only; otherwise, all
attributes for all ports will be available for
configuration.