Filter
Top Products
4 – Installation
Installing a Switch
4-4 59042-01 A
4.2.2
Install SFP Transceivers
The switch has been validated with transceivers that support a variety of
interconnection media. To install, insert the transceiver into the port and gently
press until it snaps in place as shown in Figure 4-2. To remove a transceiver,
gently press the transceiver into the port to release the tension, then pull on the
release tab or lever and remove the transceiver. Different transceiver
manufacturers have different release mechanisms. Consult the documentation for
your transceiver.
Figure 4-2. SFP Transceiver Installation
Note: The SFP transceiver will fit only one way. If the SFP does not install
under gentle pressure, flip it over and try again.