RAD Data comm IPmux-1 Network Card User Manual


 
IPmux-1/1E Installation and Operation Manual Appendix E Parameters and Screens
General Configuration E-7
Default Gateway
Default gateway defines the management next hop. When next hop is not defined
for the bundle connection the default gateway address will be used.
To configure the default gateway:
1. Type 2 (Default Gateway) in the General Configuration menu.
2. Enter the Default Gateway IP address.
The Default Gateway must be in the same subnet as the Host.
Authentication/Community
AUTHENTICATION/COMMUNITY
1. Authentication Failure Trap Off
2. Trap public
3. Read public
4. Write public
Select item from the menu.
Use <Esc> key or keys <1> to <4>
Figure E-10. Authentication/Community Menu
Table E-2. Authentication/Community Parameters
Parameter Possible Values Remarks
Authentication
Failure Trap
On
Off
On – an authentication-failure trap is generated
when a system manager attempts to set a
parameter within IPmux-1/1E with an incorrect
community value
Trap Up to 10 alphanumeric characters The entry is case-sensitive
Read Up to 10 alphanumeric characters The entry is case-sensitive
Write Up to 10 alphanumeric characters The entry is case-sensitive
Main Menu
2. Configuration
1. General
Configuration
2. Default
Gateway
Main Menu
2. Configuration
1. General
Configuration
3. Management
Configuration
1. Authentication/
Community
Note
Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com