RAD Data comm IPmux-1 Network Card User Manual


 
IPmux-1/1E Installation and Operation Manual Chapter 5 Application Configuration Procedures
IPmux-1 5-5
Configuring IPmux-1 – Station A
Procedure for Modifying Parameters
To modify parameters:
1. Choose the number of the parameter to be changed.
2. Press the <Spacebar> to toggle through the possible values.
3. Select the desired value by pressing <Enter>.
4. When you have finished modifying all the parameters on a menu, press <S>
to save the configuration.
5. To return to a previous menu, press <Esc>.
Host IP Address
Frames will not leave the device until IP and Mask addresses are defined.
To configure the Host IP Address:
1. From the Main menu, select 2 Configuration.
2. From the Configuration menu select 1 General Configuration.
3. From the General Configuration menu, press 1 Host IP (see Figure 5-2).
4. Enter the Host IP Address and Mask.
5. Press <Esc> a few times back to the General Configuration menu.
Remember to press <Enter> after modifying each parameter. Press <S> to save
all changes on the menu.
HOST IP
1. IP Address 192.168.100.11
2. IP Mask 255.255.255.0
ESC. Exit S.Save
Select item from the menu.
Figure 5-2. Host IP Menu
Main Menu
2. Configuration
1. General
Configuration
1. Host IP
Note
Note
Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com