Filter
Top Products
⎯ Program Flash
This mode is used when the emulator is used as a flash memory programmer. It cannot be
used for debugging programs.
Register the load module in the workspace to download it.
Note: It is necessary to input the ID code of the flash memory by the target device. For details,
refer to the additional document, Notes on Connecting the xxxxx.
⎯ Debugging of CPU rewrite mode
This mode is used to debug the program that rewrites the CPU. In this mode, the following
debug operations, which require reprogramming of the flash memory, are not available:
- Setting the PC breakpoint
- Changing the memory contents in the flash memory area
The debugger is activated by erasing data of the MCU flash memory. A program for the
emulator program is also written to at the same time.
Note: This mode is not supported in the H8/Tiny or H8/Super Low Power series.
When the [Execute the user program after ending the debugger.] check box is selected, the user
program is executed at the same time as the debugger operation is ended with the emulator
connected to the user system. This check box is only available when the [Program Flash] mode
has been selected.
When the [Power Target from Emulator. (MAX 300mA)] check box is selected, power will be
supplied to the user system up to 300 mA. Then select 3.3 V or 5.0 V according to the power
voltage of the user system.
CAUTION
Before carrying out the power supply, check the power
specification of the user system and there is no short circuit
in the user system. Incorrect operation will damage the user
system and the emulator product. The USER PROGRAM will
be LOST.
29