Filter
Top Products
Faxing
48
2
Reception
There are two ways you can set up
your machine to handle incoming
calls:
• Manual Reception (external tele-
phone required)
• Auto Reception
You can change the reception mode
only if a standard G3 line is used.
You cannot change the reception
mode when a line other than the
standard G3 line (G3-2) is used.
❖
❖❖
❖ Manual Reception
When a telephone call comes in,
the machine rings. If the call is a fax
message, you must switch manual-
ly to facsimile mode.
❖
❖❖
❖ Auto Reception
When a telephone call comes in,
the machine automatically re-
ceives it as a fax message. Use this
setting on a dedicated fax line.
Note
❒ The external telephone is re-
quired to use this machine as a
telephone.
Switching the Reception Mode
You can switch reception modes us-
ing the Reception Settings menu (un-
der Facsimile Features). See p.145
“Reception Settings”, Facsimile Refer-
ence <Advanced Features> .
If you program a Quick Operation
key with Switch Reception Mode, you
can switch reception mode quickly.
Preparation
You can only use this function af-
ter programming a Quick Opera-
tion key as the reception mode
switch with [Quick Operation Key 1],
[Quick Operation Key 2], or [Quick Op-
eration Key 3] under Gen. Settings/
Adjust. See p.143 “General Set-
tings/Adjustment”, Facsimile Ref-
erence <Advanced Features> .
A
AA
A
Press the [Switch RX Mode] Quick
Operation key.
B
BB
B
Select the reception mode, and
then press [OK].
The standby display appears.
Note
❒ To cancel the selection, press
[Cancel].
ThemisC1_Fax_GB-F_FM.book Page 48 Wednesday, November 24, 2004 7:09 PM