Filter
Top Products
7
9. Set Paper and RF The Set Paper indicator on the left lights when you select Bypass.
Select indicators The RF Select indicator on the right lights when you select Roll
Paper.
10. Clear Modes/Energy Cancels all current settings. When you hold down
Saver key this key for three seconds or more, the copier enters
Energy Saver mode allowing you to conserve power.
To exit Energy Saver mode, press this key again.
11. Program key Allows you to recall or set a program.
12. Function Select key Press to change which setting you are editing. The current selec-
tion is shown by the indicators
above: Paper Length
Leading Edge
Trailing Edge
Copy Counter
Also use this key to copy a selected portion of an original.
13. Plus and minus key Press to increase the setting being edited.
Press to decrease the value being edited.
14. Leading Edge/Trailing Displays the margin settings and the number of copies
Edge/Copy Counter made.
indicator
15. Bypass Select/Roll Selects the paper feed type (when the Roll Feeder
Paper Cut key option is installed). Also press to stop a copy job.
16. Copy Media key Press to select the type of copy paper you are using.
The copier will apply more or less heat accordingly.
17. Emergency Stop Press to stop the copying process immediately.
key Use if your original is getting stuck in the copier.
If you stop the operation by pressing this key, remove both the
original and paper.
18. Density indicator Shows the density level the copies will have.
Density keys Press the left key to make copies lighter.
Press the right key to make copies darker.
19. Clear/Stop key While entering numbers, press to cancel a number to have entered.
While copying, press to stop copying.
After copying has finished, press this key, then remove the origi-
nal.