Filter
Top Products
Rimage Everest III printer
4 110875_A
Control panel
The control panel, located on the front of the printer, includes an operator button
and four indicator lights. The control panel allows you to monitor and control the
Everest printer.
# Tip: If all indicator lights are blinking, the printer did not initialize properly. To
correct this issue:
1. Remove the power cord. The Everest printer powers down.
2. Set the mode switch to the proper position. For more information, refer
to the table on page
6.
3. Reconnect the power cord. The Everest printer powers on.
Control panel indicators
Image Name Functionality
Operator Button The Operator button is used to complete the following
tasks:
• Open the printer tray
• Close the printer tray
• Reset after an error
• Put the printer in sleep mode
# Tip: To put the printer into sleep mode, press and
hold the Operator button for 10 seconds. Press
the Operator button again to resume normal
operation.
The Error indicator light, located on the operator button,
illuminates when operator action is required.
Error indicator light
Disc Present
indicator light
The Disc Present indicator light illuminates when a disc
is placed on the tray or when the disc is properly
clamped.
The Disc Present indicator light flashes when an
Everest print latch is open or a ribbon is not detected.
Active indicator light The Active indicator light illuminates when the printer
has completed initialization.
The Active indicator light flashes when the Everest
printer is receiving data from the host.
The Power indicator light illuminates when the Everest
printer is powered on.
Power indicator light