Filter
Top Products
Maintain the Everest printer
110875_A 25
Cleaning the Everest printer
Clean the print head with the Everest cleaning kit
1. Power off the printer.
2. Access the print head.
a. Press the two cover latches to release the side cover.
b. Lower the side cover.
c. Open latch 1.
d. Remove the print ribbon carrier. For specific instructions, see
Changing the print
ribbon. Refer to page 21.
3. Clean the print head.
p Caution! Wipe the print head from
one end to the other. Do not stop
wiping in the middle of the print
head.
p Caution! Do not scratch the print
head. The white area in the picture
shows the area to clean.
Print head
Latch 1
Wipe
direction
a. Apply isopropyl alcohol to the sponge swab.
b. Use the sponge swab to wipe across the print head from one end to the other.
c. Repeat as needed until the print head is clean of dust and debris.
d. Use the sponge swab to remove any waxy buildup from the roller below the print head.
4. Prepare the printer for use.
a. Install the print ribbon carrier.
b. Close all latches.
c. Close the side cover.
5. Power on the printer. The printer is ready.