Rimage Everest III Printer User Manual


 
Rimage Everest III printer
32 110875_A
Safety testing
Product name: Everest III printer
Model: CDPR22
Notice for USA
Federal Communications Commissions (FCC) Warning
Any unauthorized modification to this equipment may result in the revocation by
the FCC of the user’s authority to operate this equipment.
Federal Communications Commissions (FCC) Notice
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC/IC radiation exposure limits set forth for
uncontrolled equipment and meets the FCC/IC radio frequency (RF) Exposure
Guidelines in Supplement C to OET65. This equipment has very low levels of RF
energy that is deemed to comply without maximum permissive exposure
evaluation (MPE). But it is desirable that it should be installed and operated with
at least 8 in (20 cm) or more between the radiator and the person’s body
(excluding extremities: hands, wrists, feet and legs).
Additional FCC Notices
Properly shielded and grounded cables and connectors must be used for
connection to host computer and/or peripherals in order to meet FCC emission
limits.
Safety precautions for RF exposure
This transmitter must not be co-located or operated in conjunction with any other
antenna or transmitter.
Product Safety Statement
This product complies with
UL 60950-1.