Filter
Top Products
Rimage Everest III printer
22 110875_A
4. Install the new print ribbon.
a. Remove the new print
ribbon from the packaging.
b. Install the supply roll end
of the print ribbon on the
top of the carrier.
c. Insert the large shaft in the
large opening and press the
small shaft into place.
Note: The ribbon must
come over the tacky
roller.
d. Wrap the ribbon around the
guide rollers.
e. Install the take up roll.
f. Rotate the take up roll so
the ribbon is aligned and
lies flat.
Large
opening
Small
shaft
Tack
y
rolle
r
Supply roll
# Tip: You may need to
lift the ribbon up from
the tacky roller to
straighten it.
Note: If you installed a
monocolor ribbon,
advance the ribbon so
the ink portion of the
ribbon is advanced to
the take up roll.
5. Reassemble the printer.
a. Slide the carrier into the printer.
Guide rollers
Pull handle
Supply roll
Take up roll
b. Close latch 1.
c. Close the side cover.
6. Power on the printer. The printer is ready.