Filter
Top Products
151
Editing Songs
Editing Songs
Moving to a Locate Position
Use the following procedure to change the song location to a Locate
Position.
1.
Access the Locate window.
2.
Press [1 (Jump1)] – [4 (Jump4)].
You will move to the specified locate position.
You can hold down [SHIFT] and press [BWD] to jump to the
preceding location position, or hold down [SHIFT] and press
[FWD] to jump to the next locate position.
Specifying the Area of a Song that
will Repeat (Loop Points)
When using Loop Play or Loop Recording, you can use the loop
points you specify here to specify the repeated area, as an alternative
to repeating the specified number of measures.
It is not possible to assign a loop point to a pattern.
1.
Load the song for which you want to set loop points (p. 149).
2.
Press [SEQUENCER].
3.
Press [4 (Loop)].
The Loop window appears.
fig.11-09_50
4.
Move the cursor to the desired parameter, and turn the
VALUE dial or press [INC]/[DEC] to make the setting.
• Repeat
Select the number of repeats (1–99). If you want repetition to
continue until you press [STOP], set this to “INFINIT.”
• Start Point
Specify the location at which repetition is to begin.
If you press [5 (Set Start)], the current location of the song will be
set as the starting location.
• End Point
Specify the location at which repetition will end. The location
you specify here will not be included in the repeated area.
If you press [6 (Set End)], the current location of the song will be
set as the ending location.
5.
If you press [7 (Loop)] to assign a check mark (
✔
), looping
will be turned on.
Editing Sequencer Data Over
the Specified Range
(Track Edit)
Track Edit lets you edit areas of sequencer data that you specify.
Basic Operation for Track Editing
1.
Access the Song Edit screen, and then load the song you
want to edit (p. 149).
While editing a pattern, press [SEQUENCER] and then press [2
(PTN)] to access the Pattern Edit screen.
fig.11-10.e
If you select a song that has not been loaded into internal
memory, the display will ask you for confirmation as follows:
The Song “****” is not Internal Song. Load anyway for Song
Edit? If you want to erase the song from the internal memory
and load the new song, press [8 (OK)]. If you decide not to erase
the song from the internal memory, press [EXIT].
2.
Press [SEQUENCER] and then press [8 (Track Edit)].
The Track Edit window appears.
fig.11-10a_50
Song name
Song number
Current location
Measures
containing
sequencer data
Measure number
Measures
containing no
sequencer data
Indicates the name of the currently
selected song, the measure location,
the time signature, and the sequencer status.
Indicates Loop Play and
Loop Recording
on/off (LOOP).
Indicates the song’s
playback tempo.
Reference_e.book 151 ページ ２００３年７月１４日 月曜日 午後３時２５分