Filter
Top Products
87
Creating a Performance
Creating a Performance
[4 (Offset)]
fig.06-22_50
For details on the setting, refer to
“Adjusting the Parameters of
Each Part”
(p. 84).
Part Cutoff Offset
Adjusts the cutoff frequency for the patch or rhythm set assigned to
a part.
Value:
-64– +63
Patches also have a Cutoff Offset setting (p. 44). The final Cutoff
frequency value is the sum of the tone Cutoff Frequency value
and the patch and part Cutoff Offset values. If the tone’s cutoff
frequency is already set to “127” (maximum), there will be no
change produced by setting the Cutoff Offset to a positive value.
Part Resonance Offset
Adjusts the Resonance for the patch or rhythm set assigned to a part.
Value:
-64– +63
Patches also have a Resonance Offset setting (p. 44). The final
Resonance value is the sum of the tone Resonance value and the
patch and part Resonance Offset values. If the tone’s resonance is
already set to “127” (maximum), there will be no change
produced by setting the resonance offset to a positive value.
Part Attack Time Offset
Adjusts the TVA/TVF Envelope Attack Time for the patch or
rhythm set assigned to a part.
Value:
-64– +63
Patches also contain the Attack Time Offset setting (
p. 44
). The final
TVA Envelope attack time value is therefore the sum of the tone’s
TVA Envelope Time 1 setting, the patch’s Attack Time Offset, and
the part’s Attack Time Offset. If the tone’s Time 1 parameter is
already set to “127” (maximum), there will be no change produced
by setting the Attack Time Offset to a positive value.
The same applies to the TVF envelope.
Part Release Time Offset
Adjusts the TVA/TVF Envelope Release Time for the patch or
rhythm set assigned to a part.
Value:
-64– +63
Patches also contain a Release Time Offset setting (p. 44). The
final TVA Envelope release time value is therefore the sum of the
tone’s TVA Envelope Time 4 setting, the patch’s Release Time
Offset, and the part’s Release Time Offset. If the tone’s Time 4
parameter is set to “127” (maximum), there will be no change in
the Release Time Offset, even when this is set to a positive value.
The same applies to the TVF envelope.
Part Decay Time Offset
Adjusts the TVA/TVF Envelope Decay Time for the patch or rhythm
set assigned to a part.
Value:
-64– +63
[5 (Key Range)]
fig.06-23_50
For details on the setting, refer to
“Adjusting the Parameters of
Each Part”
(p. 84).
Specifies whether the controller (keyboard) section will be connected
to the internal sound generator and MIDI OUT regardless of the
current part. Normally, you will leave this off, but you can turn it on
if you want to layer sounds.
Value:
ON, OFF
Keyboard Switch
Specifies, for each part, whether or not the keyboard controller
section will be connected to the internal sound generator.
Value:
On, OFF
Keyboard Range Lower
(
Part
Keyboard Range Lower)
Specifies the lowest note that the tone will sound for each part.
Value:
C-1–UPPER
Reference_e.book 87 ページ ２００３年７月１４日 月曜日 午後３時２５分