Filter
Top Products
3-4 Loading Material
Chapter 3 Performing Printing
31
➌
Press the Power/Movement button.
The table moves to the center.
➍
➀Press the location shown in the figure to lower the head
unit slowly to where it touches the material.
➁Keeping the area shown in the figure clamped, turn the
knob to secure the head unit in place.
Notes on Loading Material
When you lower the head unit, the metal bar also descends, and contacts the material. Secure the knob in place at the
location where contact is made with the material. The metal portion rises slightly when released, but this does not
affect the loading of the material.
Important!
➢Lower the head unit slowly. Lowering it too quickly or forcefully may damage the surface of the material.
➢When you lower the head unit, be sure to press it at the location specified in the procedure. Pressing it at
another area may cause inaccurate height alignment.
➎
Close the cover.
Detaching the Material
Loosen the knob, raise the head, then remove the material.
If the material is difficult to detach, inserting a thin, flat object (such as a piece of stiff paper or cardboard) between the
adhesive sheet and the material may make it easier to dislodge.
Power/Movement button
Lower the metal bar to a location where
it touches the material.
Knob
Press here.
Cover