Filter
Top Products
Chapter 5 Maintenance and Adjustment
72
5-5 Registration of Custom Material
Adjusting the Striking Force to Match the Material
Here you register a material and adjust the striking force to match the material's hardness and other parameters.
Procedure
➊
Windows XP
Click [Start], then click [Control Panel].
Click [Printers and Other Hardware], then click [Printers and Faxes].
Windows 98 SE/Me/2000
Click [Start].
Point to [Settings], then click [Printers].
➋
Right-click [Roland MPX-70].
If you're using Windows XP/2000, click [Printing Preferences].
If you're using Windows 98SE/Me, click [Properties].
➌
➀Click the [Image Correction] tab.
➁For [Material], select a custom material (settings a through
d).
➂Click [Details].
The [Details] window appears.
➍
Adjust the impact values.
The printing results vary according to the hardness of the material. Adjust to
match the material.
➎
Click [OK].
The [Details] window closes.
➏
Click [OK].
The setting window closes.
Raise
• When dark areas of the image are not struck
Lower
• When dark areas of the image are whitish (too bright)
• When overall striking is too forceful
Raise
• When bright areas of the image are struck with too little force (too dark)
• When overall striking is too weak
Lower
• When white areas of the image are struck with too much force