Filter
Top Products
4. 9
Printing
CONFIG
Use this tab to control the following printer features:
• Power Save determines the length of time the printer waits after a job
is printed before it goes to a reduced power state. If the printer is used
frequently, select OFF which keeps the printer ready to print with the
minimum warm-up time. This uses more electricity to keep the printer
warm and ready to print.
• Econo Mode determines the toner quantity the printer should use
when printing. If set to ON, the printer conserves toner when printing.
The default value is OFF, which provides 100% usage.
• Auto Continue determines what action the printer should take when a
manual feed print job is sent to the printer and there is no paper in the
MP Tray. If set to ON, the printer will pick up the paper from cassette
after fifteen seconds. Otherwise, the printer will wait for you to load
paper in the MP Tray.
• Jam Recovery determines what action the printer should take when a
paper jam occurs. When set to OFF, the printer does not reprint a page
that has jammed. When set to ON, the printer keeps the image in
memory for a printed page until the printer signals that the page has
successfully printed. The printer reprints all jammed pages.
• Altitude helps the printer optimize its output depending on the air
pressure of the region. If you are close to sea level, it should be set to
“Low.” If at a high elevation (1,500 m / 5,000 ft or higher), set it to
“High.”
JOB
Use this tab to control the following printer features:
• Timeout determines the amount of time (in seconds) the printer will
wait before printing the last page of a print job that does not end with a
command to print the page or a formfeed character. Valid range is 0 to
300 seconds.
• Paper Type provides the printer with information about the type of
paper to be used for a print job. If you use paper with a weight of more
than 42 lb. (90 g/m
2
), or an envelope, set this to Thick and use the MP
Tray’s manual feed slot. Otherwise use the Normal setting.
• Toner Density determines the overall density of the printed image.
Valid selections are Light, Medium and Dark.
• Image Quality mode makes the printer optimize the print quality to
1200 dpi image quality.