English
Preparation 20
Connection and Communication Setup 2
Check Setup:
• Type:
To operate a hard disk digital recorder with
a multiplexer function, this should display
“DVR/MUX”.
• Protocol:
When “DVR/MUX” is selected for “Type”,
“SANYO DVR/MU” is automatically
displayed.
• Baudrate:
“19200” is automatically displayed.
Match the settings of the connected
equipment.
3
Press the button.
Returns to Communication Setup
selection screen.
4
Press the button, select
“2–TELEMETRY”, then press
the button.
The “2–TELEMETRY” screen is
displayed. Check that the settings are as
shown below.
Check Setup:
• A-Connector:
To operate a camera via video equipment,
this should display “Video”.
• A-Protocol:
When “Video” is selected for “A-Connector”,
“SANYO SSP” is automatically displayed.
• A-Baudrate:
Because 1–VIDEO is then set to “Baudrate
(19200)”, “– – – – –” is displayed by default.
5
Press the button.
Returns to Communication Setup
(COMMUNICATIONS).
6
Press the button.
Displays Control Setup (ACCEPTED
VALUES) screen.
For “1–CAMERAS” setup, see P47.
7
Press the button, select
“2–MONITOR/LOCAL
DVR-MUX”, then press the
button.
Set the connected DVR-MUX.
8
This completes the setup.
Proceed to operating the hard
disk digital recorder (P32) or
the camera (P38).
esc
ent
ent
1-VIDEO
>2-TELEMETRY
3-SERIAL TESTS
COMMUNICATIONS
COMMUNICATIONS
ent
esc
2-TELEMETRY
2-TELEMETRY
>A-Connector Video
A-Protocol SANYO SSP
A-Baudrate -----
B-Connector Telemetry
B-Protocol ----------
B-Baudrate -----
COMMUNICATIONS
COMMUNICATIONS
esc
ent
>1-VIDEO
2-TELEMETRY
3-SERIAL TESTS
COMMUNICATIONS
COMMUNICATIONS
ent
(Figure 2)
1-CAMERAS
>2-MONITOR/LOCAL DVR-MUX
3-FUNCTIONS
ACCEPTED VALUES
ACCEPTED VALUES
ent
esc
2-MONITOR/LOCAL DVR-MUX
2-MONITOR/LOCAL DVR-MUX
> 1
11
21
31
41
51
61
71
81
91
ACCEPTED VALUES
ACCEPTED VALUES