Sanyo VSP-9000 Network Card User Manual


 
English
System Setup 56
Setup (CONFIGURATION)
6
Press the button.
The coordinates at the lower right are
placed in memory, and change to
= = = = =.
7
Press the button.
The coordinates at the upper left and
lower right are in memory.
b
bb
b Touch Screen Initialization and
Reset
Initialize the set coordinates, and set the
coordinates again.
1
Remove wiring and power
cables for all equipment
connected to this unit.
2
Turn dipswitch (SW1) ON.
3
Connect the power cable for
this unit.
The DOWNLOAD MODE screen is
displayed.
4
Operate the joystick as shown
in the figure.
A ...reset touch message is displayed,
and the touch screen is initialized.
When the coordinates are
memorized at dramatically offset
positions, this unit will not
function. Proceed to the settings in
Touch Screen Initialization.
enter
SAVE
ESC
ESC
SAVE
SAVE
-----
-----
03572
00737
SW
ON
1
234
**************************************
**
**
** DOWNLOAD MODE
DOWNLOAD MODE
**
** **
** ...WAITING FOR A COMMAND **
** **
** Firmware
Firmware
**
**************************************
1
3
2
**************************************
**
**
** DOWNLOAD MODE
DOWNLOAD MODE
**
** **
** ...WAITING FOR A COMMAND **
** **
** Firmware
Firmware
**
**************************************
... reset touch