Filter
Top Products
SWITCHES AND SENSORS CL408 and CL412
Ribbon End Sensor: This sensor is a motion detector that signals the printer
when the ribbon supply is turning.
Head Open Switch: When the print head is opened, this switch is activated
and the printer will stop printing.
Label Sensor Unit: This sensor unit contains two types of sensors, one for
label gap and one for Eye-Mark sensing. The sensors
are adjustable over a limited range.
Top Access Door
Interlock:
This switch prevents printer operation when the Top
Access Door is open.
Front Access Door
Interlock:
This switch prevents printer operation when the Front
Access Door is open. The Top Access Door must be
open before the Front Access Door can be opened or
closed.
Top Access
Door
Interlock
Front Access
Door Interlock
Switch
Ribbon
Motion
Sensor
0.25" to 2.1" (6 mm to 53mm)
Eye-Mark Sensor
0.67" to 2.5" (17mm to 64mm)
Label Gap Sensor
Minimum
Inter-Label Gap
0.12" (3 mm)
Backing
Paper Inside
Edge
Label Inside Edge
Label
Feed
Direction
Inside Label Guide
Miminum Eye-Mark Size
.12 in (3 mm) W x .24 in. (6 mm) L
Note: These positions are different
from the M84XX printers.
CL408 and CL412 Label Sensor Positioning
Section 2. Installation and Configuration
SATOCL Series Printers9001035 Rev. EPage 2-19