Filter
Top Products
OFFSET
When the printer is in dispense mode, the Feed Offset is used to correctly position the
label for dispensing/cutting. Once the correct Feed Offset is obtained, the printer will
position the label for dispensing/cutting and then reposition the next label before
printing.
The amount of backfeed is controlled by the OFFSET potentiometer on the front
panel. When turned all the way clockwise, the amount of backfeed adjustment is
+3.75 mm, and -3.75 mm when it is turned all the way counterclockwise.
1. Turn the printer on.
2. Press the LINE key to place the printer in the Off Line status.
3. Press the FEED key to feed out a blank label.
4. Adjust the position using the OFFSET potentiometer on the front control panel and
feed another label by depressing the FEED key.
5. When the adjustment is correct, turn the printer off.
ABCDEFG
ABCDEFG
ABCDEFG
Original Print
Line
Moved with
Minus (-) Offset
Moved with
Positive (+) Offset
Label Feed Direction
Section 2. Installation and Configuration
Page 2-409001035 Rev. ESATOCL SeriesPrinters