Filter
Top Products
1. Use the LINE key to step the underline to either the positive (+) or negative (-)
selection. A positive selection increases moves the horizontal reference point for
the label to the right edge of the label, towards the outside, while a negative
selection moves the horizontal reference point for the label to the left, towards
the inside of the printer.
2. Once the correct direction setting is underlined, pressing the FEED key will accept
the setting and advance to the Horizontal Offset adjustment.
3. Use the LINE key to step the counter to the desired setting. The display will
increment one step for each time the LINE key is pressed. If the LINE key is held
pressed for more than two seconds, it will automatically go into the fast scroll
mode. The reading will advance to the maximum setting setting (the maximum
Horizontal Offset) after which it will automatically wrap and start at “0000”
again. The Horizontal Direction set in the previous step will be displayed in front
of the Offset setting.
CL608 CL612 CL408 CL412
Horizontal Offset +/-1216 +/-1984 +/- 832 +/-1248
Note: The CL printers will not “wrap” images that extend beyond the print area.
Any part of the image that extends beyond the print area will be truncated.
4. Once the setting is correct, pressing the FEED key will accept the setting and
advance to the Sensor Threshold display.
ABCDEFG
ABCDEFG
Original Print
Line Position
Moved with both
Vertical and (+)
Horizontal Offset
Label Feed Direction
Inside Label Edge
HOR. OFFSET
H+ 000
0
Section 2. Installation and Configuration
SATOCL Series Printers9001035 Rev. EPage 2-31