Filter
Top Products
6. After you have set the calendar, pressing the FEED key will accept the setting and
advance to the Ignore CR/LF display.
Ignore CR/LF
This selection tells the printer to strip out all carriage return/line feed pairs (CRLF )
from the data stream, including graphics and 2D bar codes. It is used primrily to
maintain compatibility with earlier models of SATO printers.
1. Use the LINE key to step the underline cusor to either the YES or NO selection.
2. Once the correct setting is underlined, pressing the FEED key will accept the
setting and advance the display to the Print Darkeness display.
Print Darkness Type
This selection provides a dual level heat control. The normal setting is Type 1 which
provides head energy control for normal label printing, such as typical shipping
labels. The Type 2 selection provides better control of the head heat for high print
density labels.
1. Use the LINE key to step the underline cusor to either the “1” or “2” selection.
2. Once the correct setting is underlined, pressing the FEED key will accept the
setting and advance the display to the Exit Advanced Mode display.
Exit Advanced Mode
1. Use the LINE key to step the underline cusor to either the YES or NO selection.
2. Once the correct setting is underlined, pressing the FEED key will accept the
setting. If you selected No, the display will return to the initial Advanced Mode
Setup display.
3. If you selected Yes, the printer will return to the normal OFFLINE mode.
PRINT DARKNESS
TYPE
1
IGNORE CR/LF
YES NO
EXIT ADV. MODE
NO YES
Section 2. Installation and Configuration
SATOCL Series Printers9001035 Rev. EPage 2-35