Filter
Top Products
Label Tear-Off
Command Structure <ESC>CBabb
a = + to move the print line down from the top edge of the label
- to move the print line toward thetop of the label
bb = Distance moved in millimeters (00 to 98)
Example: <ESC>CB+03
Placement: This command should be sent in a separate data
stream.
Default: Last valid setting.
Command Function To adjust the location of the first print line on the label.
Input to Printer
Printer Output There is no printer output for this command. The first print line on the
next printed label will be adjusted after the receipt of this command.
Special Notes
1. The effect of this command is absolute, i.e. if an <ESC>CB+06
command is followed by an <ESC>CB+02, the resulting setting is
2 mm.
2. The maximum range for the value stored in the printer is 98mm.
Any commands received that cause the value to exceed 00 or 98
will result in a setting of 00 or 98 respectively.
3. The value is stored in flash memory and will remain until it is
modified by another valid <ESC>CBabb command, even if power
is removed from the printer.
4. The current setting is printed out on the “Pitch Offset” line on the
test label. This setting is referenced to the sensor position which is
located 0.75" (19mm) from the first print line (V=000)
5. Separate offset settings are stored for gap and eye-mark sensing.
6. To correctly position the label after receipt of this command, the
FEED key should be pressed. If not, the first printed label will not
positioned correctly.
Page 93 PN 9001092 Rev. A SATO CX208/212 Printers
CX208/212 Programming Guide