SATO 612e Printer User Manual


 
CAUTION: If your labels are less than the full width of the print head, the outside
edge will eventually wear out a small portion of the print head, resulting in an area
that will not print. Special care must be taken if you plan to use multiple widths of
labels, since the damaged portion of the print head caused from edge wear on a
more narrow label may affect the printing on a wider label. We suggest you plan your
print formats carefully to avoid using the area of possible damage on the print head
when using a wider label. The small area of damage will have no effect on printing
with the undamaged part of the print head.
Damage from a label edge is physical damage and is unavoidable. It is not covered
by warranty. It is possible to delay such damage by always ensuring that the ribbon
used is wider than the label stock. This will help to protect the print head from label
edge damage.
LABEL SENSOR ADJUSTMENTS CL608e and CL612e
The Gap (transmissive) sensor on the CL608e and CL612e can be adjusted over a
limited range. It is located in the Label Hold-Down Assembly and can be
adjusted by loosening the Sensor Adjust Cap Screw on the front of the Label
Hold-Down and sliding the Sensor Adjust Tab to the desired position. The Gap
sensor can be adjusted from a minimum of 1.0 in. (25mm) to a maximum of 3.5 in.
(90mm). The Eye Mark sensor is fixed at 0.33 in. (9mm).
LABEL SENSOR ADJUSTMENTS CL408e and CL412e
Both the Eye-Mark (refelective)and Gap (transmissive) sensors on the CL408e and
CL412e can be adjusted over a limited range. They are both located in the Label
Sensor Unit. The assembly can be adjusted by loosening the green Sensor Adjust
knob located underneath the Label Transport Assembly and sliding the Label
Sensor Unit to the desired position. The Gap sensor can be adjusted from a
Section 2. Installation
SATO CL Series “e” Printers PN 9001074 Rev. B Page 2-11
Ribbon Rewind
Spindle
Ribbon Roll
Ribbon Path
Print Head
Assembly
Head Latch
Label Path
Label Supply
Spindle
Ribbon Supply
Spindle