Filter
Top Products
LCD PANEL PRINTER CONFIGURATION
The LCD Panel is used by the operator in conjunction with the LINE and FEED
switches to manually enter printer configuration settings. Many of these settings can
also be controlled via software commands and in the case of conflict between
software and control panel settings, the printer will always use the last valid setting.
If you load a label job that includes software settings and then enter a new setting via
the LCD panel, the manually set values will be used by the printer. If you set the
values manually and then download a job with software settings, the software
settings will be used.
There are nine modes of operation. To enter the desired mode, the KEY SEQUENCE
combination listed in the table below must be performed. The initial LCD display
message is shown for each mode.
SATO CL Series “e” Printers PN 9001074 Rev. B Page 3-9
Section 3. Configuration
MODE KEY SEQUENCE INITIAL DISPLAY PAGE
Normal POWER ONLINE
QTY:000000
3-10
Advanced LINE + POWER ADVANCED MODE 3-12
Test Print FEED + POWER TEST PRINT MODE
CONFIGURATION
3-22
Default Setting LINE + FEED + POWER DEFAULT SETTING
YES NO
3-23
Clear Non-Standard Protocol DSW2-7 ON + LINE + FEED
+ POWER
ALT. PROTOCOL 3-24
Protocol Code Download DSW2-7 ON + POWER USER DOWNLOAD 3-24
Hex Dump DSW2-4 ON + POWER ONLINE
QTY:000000
3-25