Filter
Top Products
Unit 3: Installation
SATO XL400-410e Operator Manual PN 9001135A Page 3-4
MEDIA LOADING
Perform the following steps to load media into the printer. This procedure covers only the
physical installation of media and is applicable regardless of the media type. Refer to the
Configuration unit for setup instructions.
1 Switch the printer power switch off and disconnect the power supply cord (Figure 3-3a).
2 Open the top housing cover.
3 Remove the media retaining plate from media supply spindle (Figure 3-3b).
4 Insert media onto the media supply spindle followed by the media retaining plate.
5 Release print head latch and hinged media hold-down (Figure 3-3c).
6 Feed the media up the media ramp to its respective position (Figure 3-3d).
7 Loosen set screw and manually adjust paper guide inward until media is denied lateral
movement. Retighten set screw.
8 Lower and latch media hold-down, print head assembly, and top cover (Figure 3-3e).
9 Restore power and test print label (Figure 3-3f).
Figure 3-3a, Media Loading
NOTE: Feed label media onto the platen roller. Tag media is to be fed onto
the feed roller.
Top Housing Cover
Power Supply Cord
Power Switch