Filter
Top Products
Loading the paper
❏ Fanfold continuous paper
1. Move the friction lever qtoward the front of the printer to set the
FANFOLD paper setting.
2. Set the print head adjustment leverw. In general, position 1 is used
for one-part paper. (See page 15)
3. Remove or open the rear cover eof the printer to lock the cover in
the open position.
4. Release the tractor lock levers r (upward), and move the right tractor to
the marked position as shown in the figure, and lock it in place.
5. Open both tractor covers t and place the fanfold paper so that the tractor pins are aligned with the
holes in the paper. Carefully close both tractor covers.
6. After the paper is properly installed, re-adjust the left tractor to a position to keep the paper taut (but
not too taut) between the left and right tractors.
7. To load the paper, press the PARK key or the FF key on the front panel. The fanfold paper is fed to
the top-of-form position 17/72 inch (6mm) below the top edge of the paper. The top-of-form
position can be adjusted from 0/72 inch to 180/72 inch (64mm) in the setup options.
8. The paper bail automatically lowers to press the paper against the platen when the leading edge of
the paper feeds more than one inch onto the platen.
Be careful not to catch your finger when closing the tractor covers.
Rear Cover
Left Tractor Cover
Not Too Taut !!
Left Margin Marker
Tractor Cover
Tracter Lock Lever
Right Tractor
Releasing direction
Caution
13
2. Setting up