Filter
Top Products
• TOF SET
Pressing this key sets the top of the form position at the current print head
position. However, this TOF position will not be restored after the power is
turned off.
• TEAR OFF [Used only for fanfold paper]
Pressing this key advances the perforation of the form to the paper cutter so
that the paper can be torn off from the rest.
If this key is pressed after the paper is torn off, the paper is fed backwards
and the mode is returned to the offline mode. If the ON LINE key is
pressed instead of the TEAR OFF key, the paper is fed backwards and then
the mode is changed to the online mode.
• PARK (Paper parking)
Pressing this key unloads the paper when the paper is loaded and loads the
paper when the paper is not loaded.
Fanfold continuous paper (Paper select lever in fanfold setting)
The paper is moved to the park position in the back of the printer by
pressing this key. When pressing this key with the paper in the park
position, the paper will be loaded to a print station which is between 0/72
and 180/72 inches from the leading edge of the paper, depending on the
loading position programmed in the setup option.
Single sheet paper loaded (Paper select lever in single sheet setting)
The paper in the print station will be ejected. When paper is in the paper
rack, the paper is moved to the print station by pressing this key.
• RESET
When the RESET key is pressed, the printer immediately enters the reset
state and prepares for the initialize operation, which is nearly the same
initialize operation as when the power is turned on.
TOF SET
TEAR OFF
PARK
RESET
PARK
TOF SET
ENTER
SETUP
M.RLF
LF
M.LF
FF
TEAR
OFFRLF ON LINE
P
.OUT
ON
LINE
POWER
EXIT
BIN
L C D
RESET
18
3. Control panel and operations