Filter
Top Products
14
• Numerals, letters and symbols are programmable simply by pressing the corresponding keys.
• Characters may only be entered in single size or in double size. By default, the single-size character mode
is selected. To enter a character in double size, press the
Î
key before you enter the corresponding
character.
To program the word “SHARP” in double size, do the following key-in.
• Letters of alphabets “A” through “Z”, “Ø” and “Æ”are possible to be entered in lower case or in upper case. By
default, the upper-case letter mode is selected. To enter a character in lower case, press the
Ó
key
before you enter the character. To return to the upper-case letter mode, press the
Ó
key again.
To program the word “Sharp”, do the following key-in.
• Symbols and special letters are programmable by using the
é
key. To enter a character, press the
é
key before you enter the corresponding character.
To program letters “# Ä Å” with the letter “#” being double size
Editing the characters
You can edit the characters you entered. Pressing a character key replaces the current character with a new
one. To edit the characters, use the
key.
: Backs up the cursor, erasing the character to the left.
Entering character codes
• Numerals, letters and symbols are programmable by entering character codes and the
º
key. See the
alphanumeric character code table on the next page. In this way, you can program characters other than the
characters on the programming key sheet.
XXX: Character code (3 digits)
• Double-size characters can be made by entering the character code 253.
To program the word “SHARP” with the letter “S” being double size
253
º
083
º
072
º
065
º
082
º
080
º
S H A R P
Example
XXX
º
Îé=éêAéëA
Example
SÓHARP
Example
ÎSÎHÎAÎRÎP
Example