Filter
Top Products
81
Selection of X1/Z1 and X2/Z2 reports
to be printed in the stacked report sequence
Your register is equipped with the stacked report printing function that enables multiple X/Z reports to be printed
in sequence with only a single request, up to maximum of 15 reports*. This function continuously prints a
maximum of 15 kinds of reports with a single operation.
*: Maximum 70 steps are programmable. “1 step” means the memory size used for one no-range type job no.
The range type job no. needs “8 steps”.
Job code numbers to be used are as follows.
*1 *2
*3: Both range setting and full setting are allowed.
When Z of stacked report is initiated, X only reports will be skipped.
2620
.≈
10
:
13
:
;
PrintKey operation
Example
Note
00
07
09
10
13
20
27
29
30
31
32
40
50
60
70
Job no. Report Available mode Range parameter
General report
EAN zero sales report X1/X2 mode only
Full EAN report
Full department report X1/X2 mode only
Full department group report X1/X2 mode only
PLU report *3 Start PLU code/end PLU code (1 through 999999)
PLU zero sales report X1/X2 mode only
PLU price category report X1/X2 mode only *3 Start price amount/end price amount
Transaction report X1/X2 mode only
Total in drawer report X1/X2 mode only
Commission sales report
Full clerk report
Full cashier report
Hourly sales information Range report is available *3 Start time/end time (0 through 2330)
only in the X1 mode.
Daily net report X1/X2 mode only
2620
.
≈
≈≈
:
;
Job no.
Start range
parameter
For full reporting (non-range report)
To cancel the stacked report sequence
To repeat*
*1
*2
For individual reporting
End range
parameter
*2
Procedure
2620
PGM 2