Filter
Top Products
Imaging Film
9
1. Installation
Standard wall
socket
Connecting the phone line
TEL.LINE
Imaging Film
Checking the pre-loaded sample
roll
A sample roll of imaging film has been
pre-loaded in the machine. Perform
steps 1 to 2 and 8 to 10 of Replacing
the imaging film below to check the film
and make sure it is taut.
♦The sample roll of imaging film can
print about 20 pages.
If [FILM END] appears
If [FILM END] appears in the display for
longer than 10 seconds, open the
machine (see Steps 1 and 2 of
Replacing the imaging film below) and
check the film. If the film has
completely wound onto the front spool,
replace the film. Otherwise, perform
Steps 8 to 10 of Replacing the imaging
film to remove slack.
Replacing the imaging film
Replacement film
When replacing the imaging film, use
the following imaging film:
SHARP UX-71CR (one roll)
or
SHARP UX-72CR (two rolls)
Follow the steps below to replace the
imaging film.
Note: Before replacing the imaging
film, remove any paper from the paper
tray and push in the tray extension.
TEL. LINE
socket
all.book Page 9 Monday, December 3, 2007 2:10 PM