Filter
Top Products
Sending a Fax: Auto Dialling
24
4 Press .
5 The number will appear. Press
again to store it.
Automatic redialling
If you use the phonebook or a Rapid
Key to send a fax and the line is busy,
the machine will automatically make
three redial attempts at intervals of five
minutes.
During this time, [RECALLING] will
appear in the display, followed by the
attempt number. You will not be able to
dial any other locations while the
message appears.
♦To clear the message and stop
automatic redialling, press .
♦Under certain conditions, automatic
redialling may stop before three
redialling attempts are made.
START
START
Note: If the transmission is
unsuccessful and [DOCUMENT
JAMMED] appears in the display,
remove the document as explained on
page 18.
Deleting redial numbers
Deleting a single redial number:
1 Press , and then press
or until the number you wish
to delete appears.
2 UX-P710: Press twice.
UX-A760: Press twice.
Deleting all redial numbers:
1 UX-P710: Press .
UX-A760: Press .
2 Press , .
Storing a redial number in the
phonebook
1 Press , and then or
as needed until the number
you wish to store appears.
2 Press .
3 Enter a name for the number (see
page 7).
F
F
F
F
C
C
F
F
F
F
F
Dial Tone Check
This setting determines whether or not
the machine checks for the presence of
a dial on the line before automatic
dialing.
Initial setting: NO
Note: If you set this setting to YES and
find that the machine is unable to dial,
change the setting to NO.
1 Press , , , and .
F
all.book Page 24 Monday, December 3, 2007 2:10 PM