Filter
Top Products
Messages and Signals
54
Display messages
♦If a message is longer than the display, the parts of the message will alternate.
♦If you have turned on the Caller ID function, see page 40 for display messages
related to Caller ID.
ADD PAPER & /
PRESS START KEY
(alternating messages)
This appears when a fax has been received to memory
(page 30) because there is no paper in the tray. Add
paper and press to print the fax.
A.M. IN USE
(UX-A760 only)
The answering system has answered a call and the
outgoing message is playing.
COM ERROR XX
(XX is a number used by
service technicians to
diagnose problems)
Transmission or reception was not successful. If this
message alternates with another message indicating a
problem, fix the problem and try the fax operation again.
If no other message appears, press to clear
the message and then try the fax operation again. If the
error persists, see Line Error on page 50.
COVER OPEN Open the operation panel and make sure that the print
compartment cover is completely closed (press down on
the marks on each side of the cover).
DOCUMENT JAMMED The original document is jammed. See the following
section, Clearing Paper Jams. Document jams will occur
if you load more than 10 pages at once or load
documents that are too thick (see page 17).
FAX RX IN MEMORY This appears when the Key Lock function is activated
and a fax has been received to memory because there
is no paper in the paper tray. Release the Key Lock (see
page 45), add paper, and then press to print
the fax.
START
START
Messages and Signals
all.book Page 54 Monday, December 3, 2007 2:10 PM