Filter
Top Products
Imaging Film
11
1. Installation
10 Close the operation panel.
9 Close the print compartment cover.
• Press down on the marks on
both sides of the cover to make sure
it clicks into place.
8 Turn the front gear in the direction
shown until the film is taut.
• If there is a label on the film,
continue to turn the gear until the
label is no longer visible.
7 Insert the new roll of film into the
print compartment:
a. Fit the right ends of the spools
onto the pins.
b. Place the left ends so that the
shafts of the gears fit into the
holders.
all.book Page 11 Monday, December 3, 2007 2:10 PM