Filter
Top Products
PRODUCT OVERVIEW AUTO MIRRORING
3-22
English
2. Install the HDD and replace the tray in the empty HDD bay. See Installing Hard
Drives.
3. Power on your system. There is an audible beep and the HDD LEDs light.
4. Proceed with Enabling Auto Mirroring.
Enabling Auto Mirroring
Two hard drives are required for this function.
1. Select Storage and click the Auto Mirror tab.
2. Click Enable to proceed.
Auto Mirror Function
3. Click Save to finish the setup.
Note:
If a second HDD is not installed, this function is not available.
Hot-swapping HDDs
The Auto Mirror function allows for the swapping of a HDD in RAID 1 mode.
Before you begin, locate the HDD to replace, see Checking Disks in the Disk Man-
ager function.
Note:
The rebuilding of a new hard drive may take up to eight hours.
1. Open the HDD bay cover on the front of the system.