Filter
Top Products
5
Prior to switching on the projector please read
each chapter of this manual carefully as this
manual provides basic instructions for using the
projector.The installation of the lamp assem
-
bly, preliminary adjustments and procedures
that necessitate the removal of the top cover,
must be carried out by authorised, trained te
-
chnicians. There are no user serviceable parts
inside. To ensure safe and long term reliability
please use power cables supplied with the
projector. Observe all warnings and cautions.
ATTENTION:
To reduce the risk of electric shock, disconnect
the power supply cable on the rear panel before
removing the top cover of the projector.
Refer to trained, authorised personnel for tech
-
nical assistance.
• Federal Communication Commission (FCC Statement)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful interference when the equipment is used in a commercial environment. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determinated by turning the equipment off and
on, the user is encuraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
• For customers in Canada
This Class B digital apparatus complies with Canadian ICES-003.
• For customers in the United Kingdom
ATTENTION: This apparatus must be earthed
The wires in this mains lead are coloured in accordance with the following code:
Green-and-Yellow: Earth
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your
plug proceed as follows:
The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked by the letter E or by the safety earth
symbol or coloured green or green-and-yellow.
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.
This symbol indicates the possible electric shock
hazard associated with uninsulated live compo
-
nents in the interior of the unit.
This symbol indicates the presence of important
instructions regarding use and maintenance of
the product.
2 IMPORTANT SAFETY INSTRUCTIONS
The HT300 E-LINK system consists of two parts connected by a fibre optic cable: the DigiOptic™ Image Processor and the
Projector. In this manual references to the “unit” refer to one of the two units that make up the system.
CLASS 1 LASER PRODUCT
This product complies with fda radiation performance
standards, 21 cfr chapter 1 subchapter j.
This product complies with european standard en
60825.This product is classified as a class 1 laser
product and there is no hazardous radiation with the
safety protection. Danger! Invisible laser radiation
when open. avoid direct exposure to beam.Do not
open the covers of the product and never touch the
internal parts in order to avoid exposure to visible or
invisible laser radiation.
LAMP WARNING
If the lamp burst, accompanied by a big bursting noise,
allow a proper ventilation before return to the area .
Please refer to your nearest dealer for the substituion
of the lamp.