Filter
Top Products
Setting Use Notes
USB2 Source Enables touch for the selected video
source (VGA-1, VGA-2, HDMI or
Disabled) by associating the video
source with the laptop USB receptacle
(USB2) on the ACP.
The default is VGA-2.
When the user switches to the video
source you select in this setting, the
interactive whiteboard recognizes
touch from the device connected to the
laptop USB receptacle on the ACP.
Selecting Disabled disables the laptop
USB receptacle on the ACP.
This setting was introduced in DDP
firmware version 1.0.0.4.
Network menu
Network and VGA
Out
Activates the projector’s VGAOut and
RJ45 connector and network features.
Status Displays the current network status
(Connected, Disconnected or Off).
The default is off.
DHCP Displays the status of the network’s
Dynamic Host Configuration Protocol
(DHCP) as On or Off.
The default is on.
On enables a DHCP server on the
network to automatically assign an IP
address to the projector.
Off enables an administrator to assign
an IP address manually.
Password
Reminder
E-mails the network password to the
predefined e-mail recipient.
See Web page management on page
69 to set up a destination e-mail
address.
IP Address Displays the projector’s current IP
address in values between 0.0.0.0 and
255.255.255.255.
To change the projector’s IP address,
use the RS-232 connector (see
Network controls on page 86) or use a
DHCP server to assign a dynamic IP
address, and then set a static IP
address using the network remote
management feature (see Remotely
managing your system through a
network interface on page 69).
Subnet Mask Displays the projector’s subnet mask
number in values between 0.0.0.0 and
255.255.255.255.
Gateway Displays the projector’s default
network gateway in values between
0.0.0.0 and 255.255.255.255.
DNS Displays the projector’s primary
domain name number in values
between 0.0.0.0 and 255.255.255.255.
C HA PTER 4
Usingyour interactivewhiteboardsystem
29