Filter
Top Products
Command Response
get usb1source usb1source=[Video source associated with the USB 1connector on
the ACP]
get usb2source usb2source=[Video source associated with the USB 2connector on
the ACP]
TI P
The get usb1source and get usb2source commands are only applicable to SMARTUX60
projectors running DLP firmware version 1.0.0.4 or later.
These commands control the current system settings. These commands are unavailable when the
projector is in Standby mode. See Value-based command methods on page 80 for setting absolute
and adjustment commands.
Command Command target range Response
set autosignal [target] =on
=off
autosignal=[target]
set lampreminder [target] =on
=off
lampreminder=[target]
set highbrightness [target] =on
=off
highbrightness=[target]
set autopoweroff [value] =0 to =240 autopoweroff=[value]
set zoom [value] =0 to =30 zoom=[value]
set projectorid [value] =0 to =99 projectorid=[value]
set hposition [value] =0 to =100 hposition=[value]
set vposition [value] =-5 to =5 vposition=[value]
set aspectratio [target] =fill
=match
=16:9
aspectratio=[target]
set projectionmode [target] =front
=ceiling
=rear
=rear ceiling
projectionmode=[target]
set startupscreen [target] =smart
=usercapture
=preview
startupscreen=[target]
A PPEND IX B
Remotelymanagingyour systemthrough anRS-232serialinterface
88