Filter
Top Products
Source selection controls
These commands switch input sources. The source type determines which commands can be
accepted.
Command Response Available in Standby
mode
get input input=[field] Yes
set input=[field] input=[field] No
The following table describes the source selection commands:
Command Description
get input Returns the projector’s current input.
set input=[field] Sets the input to one of the selectable fields.
The following table describes the command/response definitions for switches between different
embedded applications on the appliance:
Command Response Powered off
set application [target] application=[current] No
get application application=[current] Yes
The following table describes field definitions for switches between different embedded applications
on the appliance:
Field Possible values Description
Current application
application=whiteboard
l whiteboard
l web
l pdf
l viewscreens
The appliance is currently
running this application.
Target application
set application=whiteboard
l whiteboard
l web
l pdf
l viewscreens
The appliance is set to the
target application.
The following table describes the source selection response fields:
Field Description
VGA1 Switches source to the VGA 1input connector.
VGA2 Switches source to the VGA 2input connector.
Composite Switches source to the Composite video connector.
If you installed your interactive whiteboard system according to the
instructions, this is the relay from the ACP.
A PPEND IX B
Remotelymanagingyour systemthrough anRS-232serialinterface
82